Taig Micro Lathe Basic Operations DVD

$34.90  $24.95
Save: $9.95 off

Micro-Machining with the Taig Micro Lathe
Would you like to be able to see for yourself what can be done on a Taig micro-lathe, with just minimal tooling and expense? Are you somewhat undecided about acquiring one of these small but very capable tools and somehow wished you could just see one being put through its paces before opening your wallet? Well, wait no more! Finally there is a DVD that will answer most of your basic questions about this lathe. Initial setup hints will be discussed, during a thorough tour of the lathe and its basic components. This will be followed with a complete hands-on demonstration of all the basic machining operations possible on this tool. These will include:
Facing;
Turning;
Grooving;
cut off or parting cuts;
chamfering;
center drilling;
drilling;
reaming;
tapping;
thread cutting with a die;
boring cuts;
milling and much more!
Basic Taig Micro-Lathe Techniques
Running Time: Approximately two hours


Add to Cart:

  • Model: 6-5001
  • Shipping Weight: 0.1kilos
  • 2 Units in Stock

Your IP Address is: 23.20.64.16
Copyright © 2017 Taig Australia. Powered by Zen Cart